A lot of people assume drilling to be a straightforward procedure. You could also have similar thoughts in your mind. But, this is not the case. It seems like a simple job from the outside, but it is ultimately the opposite of the inside.
Even if you focus on performing minor drilling work at your home, you need to be well-versed with the know-how. Also, it would be best if you were well-prepared to complete the job effectively.
You cannot expect to lift the machine as well as start drilling the holes. To successfully avoid many of the common mistakes, you need to concentrate on taking extra precautions.
In the below-mentioned section, you will learn about some of the most common mistakes related to diamond drilling services in Kent.
By knowing about these particular mistakes, you will prepare yourself for any drilling. Ultimately, it will lead to a more effective and better diamond driller.
Mistakes To Avoid
Making Use Of The Wrong Bit
It is such a mistake that is prevalent mainly in people who are new to the trade. One of the best ways to avoid this sort of mistake is to do adequate research beforehand.
It would help if you had a proper understanding of what you are going to be drilling into. Along with that, you should also decide how big a hole you will make and the kind of depth you will be drilling to.
If you have a requirement of a hole saw, there is no point in turning up precisely with a spade bit.
Getting Your Speed Right
One of the most important things you should consider is that faster drill speed does not mean more effective drilling. The primary purpose behind this is to work at a particular speed where the bit can grip the material precisely being drilled.
It tends to take off an adequate amount of material every time. So, you should avoid working too fast.
Otherwise, there is a possibility that you can glaze over the material, and also, the bit cannot grip enough of the material for cutting.
On the other hand, if you drill too slowly, then there are chances that the bit can get stuck while you try to cut but not taking any material off. You would be able to deal with such particular issues by getting the speed right.
Allowing Overheating Of The Drill Bit
Temperature regulation is considered one of the most integral aspects of rigid material (high speed) drilling. So, if you allow overheating of the bit or drill, it can result in shutting down the entire operation.
Due to this particular reason, it becomes very much essential to maintain a reasonable temperature.
It is something that will effectively improve the efficiency of the drill. Also, you would be able to perform your job quickly. It will also contribute to making your tools long-lasting.
Keeping Bits And Surfaces Clean
Before you get started with the work, you need to take care of this thing essentially. You should ensure that all of your bits and tools are well maintained and clean.
Other than that, it would help to make sure that the particular surface that is about to be drilled is prepped, clean, and ready.
Before drilling, one should always focus on prepping their surface. It is something which will make your job easier, cleaner and quicker.
Ensuring That The Drilling Is Lubricated Well
Whenever you conduct a robust diamond drilling operation on any surface, it goes explicitly through extensive heat. This creation of heat potentially leads to corrosive damage to the tooling.
But, don’t worry, it is possible to deal with such situations by using the proper lubricant. Water plays a significant role in preventing unnecessary friction.
Also, it tends to keep the temperature down and thereby making the process far more accessible.
Final Words
So, the above-discussed ones are the most common related to diamond drilling Kent that one should necessarily keep in mind.
Any people who are just getting started will come across these common mistakes. But, if you focus on following this advice, you will be able to avoid them.
It makes you more efficient and faster. The best part is that you will save a lot of money in the long run as you do not have to keep replacing drill bits and tools.
