Lamp Maintenance
Whether you have a UV lamp from beauty supply store in Orlando that uses fluorescent bulbs or LED bulbs, it is an investment that you want to see last as long as possible. Because not all lights are made with the same materials, you must know if your light is solvent-resistant or not. If you use acetone or acetone-based chemicals to clean your lamp, they may cause some of the components to melt. Most contaminants may be removed from your lamp using a soft cloth and 99 percent isopropyl alcohol. Lamps, like your tabletop and surface surfaces, should be cleaned after each customer.
It’s critical to keep track of the bulb-changing schedule if you’re using a UV lamp with fluorescent bulbs. You may also clean the bulbs with 99 percent isopropyl alcohol to prevent product or dust buildup from obstructing the UV light and causing your enhancement or manicure coatings to fail. According to industry scientist Doug Schoon, florescent-style bulbs may be flipped around halfway through their usage. The clean side of the bulbs, which had been facing the lid of the lamp, now faces the nails, while the exposed side, which may have some cured substance obstructing the UV radiation, now faces the lid. These lamps require bulb changes two to three times each year on average.
LED bulbs are not intended to be removed or replaced, therefore keep an eye out for any areas the client may have unintentionally handled and left the product on. When you wash off the lamp after each customer, you may do a fast bulb examination. Both UV and LED lights should be changed after three years of typical use.
To minimize bending at strange angles, tripping and pulling the lamp off the table, and unnecessary wear, keep cords out of the way. If you put the lamp anywhere else than the top of the table, take care not to damage the cord and to maintain the lamp’s shell or casing.
Electric Filers
Your e-file must be maintained clean, which is no simple chore given how much dust it generates. To begin, place a shield on the bit to assist protect the front of the handpiece, preventing dust from blocking the front bearing. A proper ventilation system will also keep dust out of your handpiece while it is in operation. Wipe it down after each service to keep excess dust at bay.
The motor of your e-file is housed in the handpiece; the control box is merely the circuit board and transformer, so don’t drop or throw the handpiece. “Your handpiece does not have to be maintained yearly,” says Bruce Atwood, president of the e-file producer Atwood Industries. That is a squandering of funds. Send it in for service only if you hear an uncomfortable high-pitched sound, or if it starts to slow down and/or gets too hot to hold.”
Your parts will also need to be cleaned correctly to avoid breakage or rust. Wash them with soap and water, then scrub them with a brush to remove dirt before disinfecting or sterilizing them with your chosen solutions. Follow the disinfection instructions to the letter; the pieces should not be kept in the liquid for an extended period of time. Leaving metal in liquids for an extended period of time can result in premature wear and corrosion.
